Questions tagged [peltier]
7 questions
3
votes
2 answers
4 Pelteir Plate Water Bottle wired to Arduino Uno
Note - I plan to use the Arduino Starter kit to make this project.
Hey everyone,
I've had an idea for a project recently and I would like to get some insight on its plausibility. Is it possible to heat and cool a bottle of water using 4 pelteir…
czhang07
- 31
- 2
1
vote
1 answer
How to control one Mosfet with another mosfet
I've got 4x 12V 6a peltiers and some 3d printer mosfet controllers to drive them using PWM with my arduino. But I've found the mosfets need ~7V to switch on, so I'm now wanting to control them with some logic level ones I had around. I could just…
Oliver Walters
- 153
- 1
- 9
1
vote
2 answers
Powering Peltier using solar panels
I am a beginner to electronics and trying to make a portable air conditioner using a Peltier cooling pad (12V). I am planning on using a solar panel to power the Peltier and looking forward to your expert opinion for below;
- Is this…
Indee
- 43
- 9
1
vote
1 answer
Connecting Peltier module to Arduino Nano
I am a beginner to Arduino programming and started working on my first Arduino project recently to power a Peltier cooling pad. Below is the code I used and in the circuit,
I connected the positive (red wire) end of the Peltier to D12 of Nano…
Indee
- 43
- 9
1
vote
1 answer
How to set PID parameter Kp, Ki and Kd?
Right now, I'm working with Peltier module using PID algorithm. I search out on the Internet about this and so I found that there are three parameters Kp, Ki and Kd. And everyone uses the different value for that. So, they actually calibrate that…
Hasan
- 1,486
- 14
- 28
0
votes
1 answer
Part of Board exploded when Peltier Plate was wired t(o Board
Photos and Screenshots: https://i.sstatic.net/NazA6.jpg
By the way, I used a screenshot that was originally from this post: Have I bricked my Arduino Uno? Problems with uploading to board
Hey guys,
I was trying to wire two TEC1-12706 Peltier plates…
czhang07
- 31
- 2
-2
votes
2 answers
Connecting Arduino to a Peltier Module
I am trying to make a cooler using Peltier Modules, the Peltier Modules and the fans switch on when the Temperature sensor attached to the circuit reads above a certain threshold. But I know that Arduino can only handle a couple of MilliAmps as its…
Kv07
- 25
- 7