Arduino Pro Mini ATmega 328P 3.3V 8MHz, connected to USB port via USB to Serial breakout board built around the FT232RL FTDI chip. JTAGenum project code uploaded to the Arduino. I opened terminal and tried to run test command (without connecting wires between target and Arduino), but terminal output show garbage values. The baud rate of the serial console has been set 115200, as specified in JTAGenum code. Not sure whether this issue can be related to CPU_PRESCALE defintions in code.
Asked
Active
Viewed 669 times
1
minto
- 221
- 2
- 9