1

I have created an arduino prototype using the exact instructions found on this page:

https://www.arduino.cc/en/Main/Standalone

However, when I plug in the micro USB power supply and try to upload a program, here's the error I get:

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xe0

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0xe0

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0xe0

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0xe0

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0xe0

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0xe0

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0xe0

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0xe0

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0xe0

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0xe0

I have tried the following solutions, to no avail: 1) press the restart button (in a variety of ways and lengths of time) 2) Enable verbose output 3) trying the different board types in the Arduino IDE 4) Checking the COM port

I have no idea what to do I've basically tried everything I could find, on this website and others.

I hope you guys can help! Thanks very much :)

Avamander
  • 624
  • 2
  • 11
  • 35
Hassan M
  • 171
  • 5

2 Answers2

0

Remove the pins connected to Tx and Rx while uploading the code , it worrked for me. also include all the libraries currently used in your program. Good luck!!

elvis
  • 1
0

Check for Baudrate, the Arduino Serial Terminal, and serial port terminal should exactly match.

Or either check your Rx and Tx pins for respective voltages Either there may be problem related to power supply. It is better you also mention the code

Chaitanya
  • 1
  • 1